Specifications Nominal coil voltage: 12 V DC Operating voltage range: 10.8 ~ 13.2 V DC (±10% tolerance) Coil resistance (±10%): 330 Ω Rated coil power consumption: 0.44 W Max pick-up voltage: ≤ 75% Un (9 V DC) Min drop-out voltage: ≥ 10% Un (1.2 V DC) Coil protection: Integrated freewheeling diode for inductive spike & reverse polarity protection Status indicator: Green LED, illuminated when coil is powered Contact Electrical Specifications (1CO SPDT) Contact configuration: 1 Form C (1 normally open + 1 normally closed) Contact material: AgNi silver-nickel alloy Rated switching capacity: Resistive AC: 6 A / 250 V AC Resistive DC: 6 A / 30 V DC Minimum guaranteed switching load: 1 mA / 5 V DC (stable micro-signal switching) Mechanical service life (no load): 3 × 10⁷ cycles Electrical service life (6 A, 250 V AC resistive): 1 × 10⁵ cycles Max full-load switching frequency: 0.1 Hz Insulation & Dielectric Strength Isolation type: Reinforced galvanic isolation between coil and contacts Dielectric withstand voltage (coil ↔ contacts): 2500 V AC / 1 min Impulse surge withstand voltage (1.2/50 µs): 6 kV Rated insulation voltage: 250 V Overvoltage category: III; Pollution degree: 2 Clearance & creepage distance between coil and contacts: ≥ 5.5 mm Mechanical & Matching Socket Info Installation mode: Plug into matched TRP DIN rail socket (socket ordered separately) Relay insert dimensions (W × H × D): 13.5 mm × 58 mm × 40 mm Relay insert net weight: ~26 g Housing material: Black UL94 V-0 flame-retardant PA66 plastic Protection class: IP20 (for installation inside control cabinets only) Vibration resistance: 10–55 Hz, 1.5 mm amplitude per IEC 60068-2-6 Environmental Conditions Operating ambient temperature: -40 °C ~ +60 °C Storage & transport temperature: -40 °C ~ +70 °C Relative humidity: 5% ~ 93% RH, non-condensing at 40°C Max operating altitude: ≤ 2000 m above sea level Compliance & Certifications Marking: CE marking Environmental compliance: RoHS 2011/65/EU, REACH SVHC registered Applicable standards: EN 61810-1, EN 61010-1, EN 50178