Key Technical Parameters Type ACT20P-CI-2CO-OLP-S Version Passive isolator, Signal distributor, Output current loop powered Number of Channels 1 Input / 2 Outputs Input Specifications Parameter Value/Description Number of Inputs 1 Input Signal 4...20 mA Sensor Type Current source, 4-wire sensor (with own power supply) Voltage Drop, Current Input < 3 V Output Specifications Parameter Value/Description Number of Outputs 2 Output Signal 2 x 4...20 mA, loop-powered Output Type Passive (connected control must be active) Load Impedance Current RL = (UB-12V)/20 mA, e.g., 600 Ω at 24 V Power Supply Parameter Value/Description Voltage Supply via output current loop, min. 12 V DC / max. 30 V DC Nominal Power Consumption 2 VA General Specifications Parameter Value/Description Accuracy < 0.1 % of end value Step Response Time ≤ 2 ms Temperature Coefficient ≤ 100 ppm/K Configuration None (fixed) Galvanic Isolation 3-way isolator (Input, Output 1, Output 2) HART® Signal Forwarding Unchanged Mounting Rail TS 35 Protection Degree IP20 Operating Altitude ≤ 2000 m Isolation Parameters Parameter Value/Description Insulation Voltage 2 kV (Input/Output), 1 min, 50 Hz Impulse Withstand Voltage 4 kV (1.2/50 µs) Rated Voltage 300 V Pollution Severity 2 Overvoltage Category III Dimensions & Weight Parameter Value/Description Width 12.5 mm Height 117.2 mm Depth 114 mm Net Weight 105 g Temperature Ranges Parameter Value/Description Operating Temperature -20 °C ... +60 °C Storage Temperature -40 °C ... +85 °C Humidity 5...95 %, no condensation Connection Data Parameter Value/Description Connection Type Screw connection Tightening Torque, min. 0.4 Nm Tightening Torque, max. 0.6 Nm Clamping Range 0.5 ... 2.5 mm² Wire Gauge (AWG) AWG 26 ... AWG 12