Key Specifications Parameter Specification Model TL-Q5MD1 Type Inductive Proximity Sensor Shape Rectangular / Square Shielding Unshielded (Non-shielded) Output Configuration DC 2-wire Operation Mode NO (Normally Open) Detection Specifications Parameter Specification Sensing Distance 5 mm ±10% Setting Distance 0 to 4 mm Differential Travel (Hysteresis) 10% max. of sensing distance Standard Sensing Object Iron 18 x 18 x 1 mm Detectable Object Ferrous metals (sensing distance reduced for non-ferrous metals) Response Frequency 500 Hz (Average value) Electrical Specifications Parameter Specification Power Supply Voltage 12 to 24 VDC (ripple p-p 10% max.) Operating Voltage Range 10 to 30 VDC Leakage Current 0.8 mA max. Control Output (Load Current) 3 to 100 mA Residual Voltage 3.3 V max. (Load current 100 mA, Cable length 2 m) Protective Circuits Load short-circuit protection, Surge suppressor Indicators Operation indicator (red), Setting indicator (green) Environmental & Physical Specifications Parameter Specification Degree of Protection IP67 - Dust-tight and water-resistant (IEC 60529) Ambient Temperature (Operating) -25 to 70°C (no icing) Ambient Humidity (Operating) 35% to 95% RH (no condensation) Temperature Influence ±10% max. of sensing distance at 23°C in range -25 to 70°C Voltage Influence ±2.5% max. of sensing distance at rated voltage in rated voltage ±15% range Insulation Resistance 50 MΩ min. (at 500 VDC) Dielectric Strength 1,000 VAC for 1 min Vibration Resistance 10 to 55 Hz, 1.5 mm double amplitude, 2 hours each in X, Y, Z Shock Resistance 500 m/s², 3 times each in X, Y, Z Connection Method Pre-wired cable (standard length: 2 m or 5 m) Head Size (W x H x D) 17 x 17 x 28 mm Housing Material Heat-resistant ABS resin Sensing Surface Material Heat-resistant ABS resin Weight (Packed) Approx. 85 g